Kayfun v4 clone positive pin locking nut

Ok. Its my own fault. I accidentally lost the nut that the positive pin of kayfun v4 screws in. Now the whole unit is useless.

Anyone knows where or how i can get a replacement for it?

 

Hi Xilver, I nearly lost mine as well (was in the bin already).

Here you might find a new one screw

Cheers


upps, misread it... no nut in the accessories-set

 

buy the cheapest clone you can find and scavenge for parts is one solution. or... abandon the site and nuke it from orbit.

it's the only way to be sure.

 

If you are referring to the nut #11 on the KF diagram then it looks like this spares kit has one: Electronic Cigarette Atomizer Accessories for Kayfun V4-2.33 and Free Shipping| GearBest.com

 

Which part # are you referring to?

Big (Moog's link) sells an accessory pack that contains parts: 1,2,4,7,9,10,11,13,14,15,19,20,21-24

 

Could be this for locking the positive pin inside.

 

I'm going blind @Scratchy is obviously the best option, I didn't see the #11 nut in the pack at first ...

 

That's included within Big's accessory pack. Part #11

**Updated**

Did you buy a pack from Big @judas? I bought two and looking at one of them, I'm not seeing a replacement spring which surprises me.

 

On looking at that picture in details, look like i am missing 2 pieces!!! Part 10 and 11.

Will check with Big.

Thanks guys. Hope i can revive the Kayfun

 

No, I bought these a while back $3.56 Spare Parts Kit for Kayfun V4 RTA Atomizers (3-Pack) 3-pack at FastTech - Worldwide Free Shipping but will probably pick up a set from GB in my next order as mine don't have #11 nut. If you need a spring I'll gladly send you one.

 

The spring i still have. I guess I am missing 2 parts. Not 1. An insulator and a nut to hold in the positive pin.

 

Big's kit is what you need then and the fastest option.

 

Thanks for the offer! I am not in need of one now but I heard of better 3rd-party springs or other types of parts to replace the spring. Lots of people point to the spring as a source of inconsistent resistance readings, particularly if you do not have the juice control wide-open and are making adjustments to juice control. Mine are always wide-open so they've been fine so far. If there's any improvement in conductivity with a different part, I'd be interested to try.

 

Mine a fine on kanthal builds as long as everything is tight but a little too much fluctuation on ni200 for my comfort so will get a couple of gold plated springs at some point to try out.

 

Sorry to hear that. Maybe something is loose? No fluctuations at all with two of three I have used with Ni200. I do have the juice flow completely wide open and also made sure all the internals are clean and well-secured.