1. Welcome to Thailand Vapers, an English language forum for members in Thailand and the rest of Asia to talk about vaping.
    Commonly referred to as e-cigarettes, vaping is really about the use of personal vaporizers (mods) and atomizers (tanks, clearos, RBAs, RDAs, RTAs) filled with e-liquid.
    Are you looking to get started or an old hand at vaping? Everyone is welcome here so sign up today and talk vaping with us!

3 in 1: Quick Tip, Product Review & Camera Trick

Discussion in 'Modifications and DIY' started by Darth Vaper, Jan 20, 2015.

  1. Darth Vaper
    Sick

    Darth Vaper Thread Starter Keep Calm and Impose Your Will on Others

    Joined:
    Jun 26, 2013
    Messages:
    954
    Likes Received:
    1,359
    Location:
    Hell, Ironic Punishments Division.
    Ok, as succinctly as a sith lord can be:

    Elkirnoggen clone. Been liking it except the positive pin is really recessed. Maybe not on yours but now 2 out of 2 over here. Won't fire on several mods. Drag. O rings of tiniest inner diameter onhand insufficient and this vaper has found o rings no matter how small will always squeeze past the positive screw. In the case of the elkinikigoen, o ring placement under positive deck, underside of base, etc did not provide enough pad to extend the pin and led to further instability.

    This product, or rather the stuff itself since it is sold under a few different names/brands... Did the trick. Looks ugly as fug but postive pin juts out. So fug er up.

    This was obtained at the standard a-hole price gouge rate from a radio shack in the states but since it was the first the stuff was made known to yers truly, could not resist and picked it up. Amazon search will provide ample selection at a fraction of the amount forked over.

    [​IMG]
    Obtained in brick and mortar shack, presently unavailable on amazon.

    [​IMG]
    Same stuff, better value. Link to product here

    If you want to prototype in plastic and do not want to plunk down real loot for a 3D printer (yet)... Here you go.

    Or if you want to extend yer positive pin and beat your atomizer with a stick at the same time... At least it is not visible.

    image.jpg image.jpg

    Take a tiny portion of the stuff, roll into tiny cylindrical shape. Bend tiny cylindrical shape into tiny donut shape. Place at bottom of thread connection before screwing in positive pin. While still unsolidified, screw in postive pin just enough to secure the contraption with the extra padding from the morphous stuff hardening to hold itself in place and the positive screw extended and secure as well.

    The plastic can be sanded down for a better look but all this activity is literally an excersize in taking productivity and pissing it up a flag pole so there is a limit and its been crossed hours ago.

    The plastic form will turn back to goo when exposed to heat from heat gun/ hair dryer or when dunked in hot water. Miracle product.

    Last: was finally able to get good detail from smart phone camera by simply holding a magifying glass up close to the camera lens.

    Probably not news to all y'all but I reconed myself a genuine Einsteinian after thinkin it then tryin it and getting a good result.

    Konnichiwa, bitches!
     
    jon, PattsVaper and Rick O-Shea like this.

Share This Page