1. Welcome to Thailand Vapers, an English language forum for members in Thailand and the rest of Asia to talk about vaping.
    Commonly referred to as e-cigarettes, vaping is really about the use of personal vaporizers (mods) and atomizers (tanks, clearos, RBAs, RDAs, RTAs) filled with e-liquid.
    Are you looking to get started or an old hand at vaping? Everyone is welcome here so sign up today and talk vaping with us!

Cleaning your Atomiser

Discussion in 'Tips and Tricks For Vaping' started by -V-, Sep 25, 2012.

  1. -V-
    Cool

    -V- Thread Starter Administrator Staff Member

    Joined:
    Jan 28, 2012
    Messages:
    11,325
    Likes Received:
    5,438
    Boil some water in the microwave and dropp in the atties. swirl them around a little to get them completely wet. after about 5 mins drain and do it again. then once more. after blowing them out put them in the oven after cooking dinner, with the door open to dry them come back and apply a couple drops on the bridge. chances are you will get the best flavour and vapour than I've ever had. but with everything it is all trial and error nothing in life is certain

    another way is the same as above but blow out all the excess water and the do a dry burn of your atomiser Connect to battery Push button until you see orange hot...carefully...not super bright (white hot). Let off button and blow down the barrel (from a distance, not with your mouth actually on it), this kind of flash cools it and also gets some of the moist air out to speed the drying process. Repeat 5-10 times... you will see that gradually (once you've got it dry) the glow will occur much quicker. Once you have it to this point, press and release the button at a rate that just holds the orange glow (kind of a manual 'pulse width modulate'). Keep this glow going for 20-30 seconds, being very careful to maintain the glow at low orange (not bright red/white) or you'll pop it. you can do this entire process again for better results (again this is not a guaranteed fix but if your atomiser is not working you got nothing to loose )

    If you atty is all gunged up and wont clean easy you can try an ultrasonic cleaner but the cheapest way is just trow your dead atomisers in water with a couple Efferdent tablets you will see all the gunk rise to the top of the foam follow the cleaning with a good hot water rinse. No problems, no aftertaste, a cleans them well dry in which ever method you like either leaving over night in a hot place of the dry burn.
     

Share This Page