1. Welcome to Thailand Vapers, an English language forum for members in Thailand and the rest of Asia to talk about vaping.
    Commonly referred to as e-cigarettes, vaping is really about the use of personal vaporizers (mods) and atomizers (tanks, clearos, RBAs, RDAs, RTAs) filled with e-liquid.
    Are you looking to get started or an old hand at vaping? Everyone is welcome here so sign up today and talk vaping with us!

Any advice?

Discussion in 'Rebuildable Atomisers' started by Calvin, Aug 6, 2019.

  1. Calvin
    Happy

    Calvin Thread Starter Member

    Joined:
    Jun 7, 2019
    Messages:
    29
    Likes Received:
    17
    Hi all,

    Bought the re-buildable RBA coil for the Smoant Pasito Pod. It looked cute...

    Use a Germaster pre-build coil, 3mm Dia, 28 or 30 Guage 6 wraps which stated 0.5 Ohm.

    But I add one more wrap to it. After installed on the deck, it showed 1.05 Ohm.

    Any idea why the Ohm double? Bcos I added one more wrap to it?

    IMG_20190806_190936.jpg
     
  2. Siam Diesel
    Lurking

    Siam Diesel Nauti Moderator Staff Member

    Joined:
    Jan 26, 2014
    Messages:
    14,139
    Likes Received:
    16,779
    Location:
    Vape Wastelands
    Did you check the resistance before adding the additional wrap? Why did you add a wrap to a pre-made coil? I don’t know if the resistance is linear or not...but if you trust your ohm meter, then the resistance with the additional wrap is 1.05 ohms as measured.
     
  3. Calvin
    Happy

    Calvin Thread Starter Member

    Joined:
    Jun 7, 2019
    Messages:
    29
    Likes Received:
    17
    My bad. That 1.05 Ohm coil was built using the wire provided with the RBA tank/coil.

    Checked Ohm meter with another pre-build coil on another tank, it was same as my mod read 0.36 Ohm. Meter no problem.

    Now build another coil with the wire provided. Meter read 1.07 Ohm.

    Pasito Pod Watts setting from 10, 13, 16, 20, 25 watt.

    Will try this rba after the cartridge ejuice empty...
     

Share This Page